Vermes
Advanced Member level 4
![](https://obrazki.elektroda.pl/9088668900_1295558422_thumb.jpg)
It is a simple amplifier on LM3886. It is a useful device for a home or small party – it is powerful and cheap and what is very important for a beginner – not too much complicated.
Supply:
The amplifier is powered from a transformer 2x28V 250W. It also uses a 35A bridge, 4x10000uF capacitor. The device is equipped with Standby system of own construction with a separate small transformer. The power supply on the rear switch does not consume a lot of energy.
Standby:
That system is based on a flip-flop. The main assumption was that the turn on should not be on a toggle switch and have a R/G diode indicating the status of the amplifier (red – standby, green – play). Executive system consists of an optotriac and triac.
Preamplifier:
The schematic of preamplifier can be found here: LINK.
Power amplifier:
It was made of a kit AVT2180 based on LM3886. It is simple and easy to make.
![](https://obrazki.elektroda.pl/1624793100_1295558404_thumb.jpg)
![](https://obrazki.elektroda.pl/8803346700_1295558406_thumb.jpg)
![](https://obrazki.elektroda.pl/6813557500_1295558409_thumb.jpg)
![](https://obrazki.elektroda.pl/7428594800_1295558414_thumb.jpg)
![](https://obrazki.elektroda.pl/4064786700_1295558416_thumb.jpg)
![](https://obrazki.elektroda.pl/4815107200_1295558418_thumb.jpg)
![](https://obrazki.elektroda.pl/2575389600_1295558419_thumb.jpg)
![](https://obrazki.elektroda.pl/8432013500_1295558421_thumb.jpg)
![](https://obrazki.elektroda.pl/9088668900_1295558422_thumb.jpg)
Link to original thread - Mój pierwszy wzmacniacz- LM3886