Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
My fault! What i mean is :when you calcurate the location of zero,
it will depend on some parameters ,such as gm ,R.
that will drift with process,temp..and then the zero will drift,cause
stable problem!
I am afraid I think:
"zero drift" is a phenomena that when input is zero, the output of OP departure the ideal point because of voltage and tempeture variety.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.