Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A question about AMBA AHB

Status
Not open for further replies.
C

chiguoquan

Junior Member level 3
Joined
Mar 30, 2006
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,410
In a burst transfer who is responsible for increasing the address？The master or the slave? Should the slave read the address from the haddr input on every clock cycles,or read the address only when htrans=NONSEQ and increase it according to hsize and hburst?
Thanks
 

Yes but why the slave need hburst and htran ? if the hadd is updated by the master, the slave need only the address. right ?
thanks
 

The slave may optimize his operation, when he knows that there will be a burst comming.
e.g. the slave can pack multiple cycles into one cycle

regards
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top