Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to switch off the optrex display (DMF5003) without affecting the analyzer?

Status
Not open for further replies.
A

abhay kulkarni

Member level 3
Joined
May 31, 2007
Messages
59
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,664
I am working on a gas analyzer in which optrex display DMF5003 is used to display concentration of measuring gas. The analyzer is located in field and it is always on. The current out put corresponding to gas concentration is transmitted to control room to get reading.
Thus I want to switch off the display on the analyzer, as it is not required always on. The display is required only at the time of clibration of analyzer. The manufacturer have not provided the facility to switch off the display.
how can I switch off display without affecting the working of analyzer?
The display module consist T6963c controller.
Is it possible to blank the display by connecting RESET pin to low?
please help me.
 

optrex display

i search the spec. of the DMF5003 i suggest you can simply disconect the power supply of the display module and connect to the switch, and if your intention just to hide just not to view the value on the display you can also adjust the trimpot/trimer of the display located at the display module...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top