Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

transmission line RLGC of quasi-static

Status
Not open for further replies.
M

myem

Full Member level 2
Joined
Dec 12, 2003
Messages
127
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
972
transmission line rlgc

I am using quasi-static simulator to analyze a whole package.
I got some porblems about that .
Why only RLC can appear , G is always equal to zero.
No matter what I increase frequency ,
LC almost not change, only R is increasing.

why ?

tks
 

rlgc transmission line

myem said:
I am using quasi-static simulator to analyze a whole package.
I got some porblems about that .
Why only RLC can appear , G is always equal to zero.
No matter what I increase frequency ,
LC almost not change, only R is increasing.

why ?

tks
Click to expand...

1. G represents the substrate loss. This depends on three parameters: dielectric constant, bulk conductivity, and loss tangent. When you have freq-independent dielectric constant and zero loss tanget, the G will always be constant. When you have bulk conductivity and loss tangent are zero, then G is always zero.
2. I don't think you can see the difference in C using quasi-static tool. In full-wave you may see a difference due to the fringing field.
3. L reduces very little as the freq goes high.

Please correct me if I am wrong.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top