Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to switch off the noise of a component in ADS?

Status
Not open for further replies.

aware_boy

Junior Member level 2
Joined
May 7, 2002
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
98
Is there any way to switch off the noise of a component in ADS. I would like to switch all the components of my circuit except one, the one which I would like to check the noise.

I have been told by setting the temperature to 0°, that would work :)

Thanks.
Boy
 

noise simulation in ads

There is a "noise" feature in "properties " dialog of every kind of circuit component. When you select " Yes" this component will produce noise , otherwise it won't be appeared in the noise contribution list..

It's quite easy..

properties=double click..
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top