Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

about corner simulations

Status
Not open for further replies.
J

JVNPAVANKUMAR

Junior Member level 2
Joined
Oct 4, 2005
Messages
21
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,281
Activity points
1,396
hi i have a basic doubt about corner simultaions

who will decide the parameters is it the designer who define the corners?
how does people define what all parameters to be varied while doing a corner simulation?

will the parameters be same in the case on both analog and mixied signal domains?
 

Hi
The model designate the parameters if the designer wants.
as I know there is no defference between analog and mixed signal corners.
regards
 

Corner model is proposed for digital circuit originally. For fast/slow NMOS and fast/slow PMOS. For analog design, designer can choose by himself. Sometimes, bipolar variation and resistor variation are added as well. Careful analog designer add corners as many as possible in simulations.
 

corner simulation is very importance of analog designer. we must run tt,ff,ss fnsp snfp.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top