Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to make copper pour in Eagle??

Status
Not open for further replies.
E

ex4

Full Member level 2
Joined
Dec 28, 2004
Messages
120
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,298
Location
Jakarta, Indonesia
Activity points
958
eagle copper pour

got confused in making copper pour in Eagle. need assistant on how 2 do it :|:|
 

eagle pour

How many layer pcb r u making?
The easiest copper pour upto 2 layer pcb i hv seen is in sprint layout.
It is like child's play.
 

copper pour eagle

i only make maximum of 2 layer, bottom and top. usully for home made pcb
but got confused on how 2 make copper pour??? use polygon or what???
 

eagle copper pouring

click "Polygon", type Gnd (or however your ground is named), choose an appropriate width > 0 (unless you want to bother your PCB manufacturer ) and draw the ground plane. You can see the plane after clicking "Ratsnest" - that's it
 
copper pour in eagle

wow, nice :D
btw, how to change the gap between the pour and the signal copper line?? or anybody complete eagle tutorial that cover this detail matter??
 
eagle pcb copper pour

This can be adjusted with the Isolate parameter. But you should consider the help on that matter as it additionally depends on the design rules (type: "help polygon")
 
copper pouring eagle

i usually use 2 layer pcb design, with the top layer is set as jumper layer. i can easily do it in orcad, how 2 set it up in eagle??
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top