Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

KU band stripline BPF?

Status
Not open for further replies.
B

biff44

Advanced Member level 6
Joined
Dec 24, 2004
Messages
5,046
Helped
1,376
Reputation
2,748
Reaction score
1,056
Trophy points
1,393
Location
New England, USA
Activity points
37,902
ku stipline

Anybody out there ever have any luck getting a strip line (two soft boards sandwiched together) bandpass filter to work at say 13 GHz?
 

stripline bpf

Yes, it a very standard approach to distributed microwave filters. However, the feasability is mostly dependent upon the bandwidth of the filter, and the thickness of the stripline substrate. Please provide a little detail, including loss and attenuation characteristics if possible.
 

i have seen many as microstrip but not strip line in the satellite LNB it is implemeted as microstrip BPF

khouly
 

I sure you could but I'm limited to one side of board (low cost) so always use microstrip.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top