Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

RADIAL PLACEMENT IN ALLEGRO

Status
Not open for further replies.
V

v_kumar

Full Member level 5
Joined
Jun 2, 2004
Messages
272
Helped
18
Reputation
36
Reaction score
3
Trophy points
1,298
Location
India
Activity points
1,964
can anyone let me know the procedure to do radial placement in allegro.

thanks
 

select the component which one is going to place, enter the radius in project manager table..
 

select move command, select the component, set the radial type in options column...
 

which verision do you use
i dont see any radial option in the options tab after selecting the move commond..
i am using allegro 15.7 PCB DESIGN L.
 

sorry..my answer is not fully correct...its in 15.7 version...its not a radial..its a polar option for radial placement
 

Amazing how this question was asked TWICE in less then few days, and I replied CORRECTLY and still is being asked!!!




Regards,

M
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top