Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Need help "stk500.ebn" how can I convert to "

Status
Not open for further replies.

tuinui98

Junior Member level 2
Joined
Dec 18, 2002
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
138
stk500.hex

Hi, everybody.

Now I created AVR programmer board HVProg

It's a STK500 cloned, used with many type of AVR and support firmware upgrading by AVRStudio. And my interesting is High Volt Parallel Programming mode.

But my big problem is How to program firmware to ATMEGA8535 in HVProg.

Because of AVRStudio is including firmware of STK500, but the format is *.ebn

C:\Program Files\Atmel\AVR Tools\STK500\STK500.ebn

Now I can program AVR by SI-Prog via PronyProg from Lancos.

This program supports firmware file many format, but excluded *.ebn



Somebody can convert *.ebn format to *.hex please.

Thank you.
 

stk500 hex

Hi,

You can make an AvrProg to program At90s8535 ou AtMega8535 with stk500.ebn, Atmel uses AvrProg to update Stk500, give a look here **broken link removed**

psilva
 

ebn2hex

Run:

ebn2hex.exe stk500.ebn stk500.hex
 

    V

    Points: 2
    Helpful Answer Positive Rating
stk500.ebn

This extension are ATMEL specific format for uploading ...
They have a bootloader on STK500 which can encode the firmware file...

May be the enb2hex can help...
I like to try it too...
 

Re: stk500.ebn

This extension are ATMEL specific format for uploading ...
They have a bootloader on STK500 which can encode the firmware file...

May be the enb2hex can help...
I like to try it too...

Here you are :
 

Attachments

  • stk500_work.rar
    9.4 KB · Views: 210
Re: stk500.ebn

my problems with dre hammer stk500:
1 avr studio /the new one/ in communication was set to 9600b/s,and stored.when I uninstall ,and install older verson with 115200b/s HV start's at the first time!
ps i made a advanset version with dip atmega and IC's and smd rezistors and C
2 with the target board -too long HV programing cable ,Atmega 8 do not respond at SPI ,but in HV mode was ok.so i made a board for SPI for atmega8....:-(
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top