Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Protel 99SE, avoid autoroute certain nets

Status
Not open for further replies.
D

davorin

Advanced Member level 3
Joined
Jun 7, 2003
Messages
901
Helped
11
Reputation
22
Reaction score
4
Trophy points
1,298
Location
Switzerland
Activity points
7,349
Evening (o;

I tried several ways that a single-sided PCB has a GND plane
and that Protel 99SE should not route GND...

Whatever I do he still routes GND although it is connected
through GND plane already.

Tried with "Classes" as GND being not a member. But it says
that the "Rule not followed by router"...

Any easy way to avoid certain nets to be routed?
 

I think that your problem is that you have a 2 sided board instead of a single layer board. I am not familiar with 99se but in protel_dxp you can define a net as a plane. And of course it is needed to reserve a layer for this plane.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top