Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to make a sine wave generator?

Status
Not open for further replies.
showntimoon

showntimoon

Junior Member level 3
Joined
Aug 27, 2006
Messages
28
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Activity points
1,478
i want to make a circuit that generates a sine wave with a specific freq.
how can it be done ??
 

Re: sine wave generator

You want to make a VCO? i.e. programmable output frequency?
Or you seek fixed frequency?
What about the linearity you seek?

Good Luck,
Ahmad,
 

Re: sine wave generator

yeah I seek fixed frequency
but I don't know wat u mean with linearity ??
 

Re: sine wave generator

Linearity can be expressed by the amplitude of fundamental freq. component (freq. you want) relative to adjacent second harmonic freq. component.

Linearity is the best if your oscillator has only single fundamental component..

You can make a simple sinusoidal oscillator using a 555 oscillator and simple LPF..

Depending on frequency.. This can give you relatively lwo freq. (up to few hundereds of KHz).

If you seek higher frequencies, you will go to XTAL or LC oscillators..

Hope that helps..
Ahmad,
 

    showntimoon

    showntimoon

    Points: 2
    Helpful Answer Positive Rating
Re: sine wave generator

hi.to design a sinewave generator,the crystal oscillator would be the obvious choice.most of the applications use this.
 

sine wave generator

you can make it with a chain of inverters. it's very easy!
 

Re: sine wave generator

showntimoon said:
i want to make a circuit that generates a sine wave with a specific freq.
how can it be done ??
Click to expand...

Hello

An simple circuit is the Wien Bridge

You can find in this forum

Regards
 

Re: sine wave generator

thank u all for help
plz could u give me the circuit using the 555
[/youtube][/GVideo]\][/quote]
 

Re: sine wave generator

I haven't the circuit but the idea is put a band-pass filter in the output of the 555 (pin 3) when this is in astable configuration
 

    showntimoon

    showntimoon

    Points: 2
    Helpful Answer Positive Rating
Re: sine wave generator

If your frequency is as low as 90KHz, then you can go with one of 555 astable oscillators that're available free online, and choose your R's and C components values, untill you get the required freq. of oscillation..
Then Simply cascade a low pass filter with output of this oscillator (pin 3).. Make sure that cut-off of that filter is close to the required frequency..

You can download a free demo of similar calculator from the link below:
**broken link removed**

Best Wishes,
Ahmad,
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top