Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to extract L, C for microstrip antenna in HFSS V10?

Status
Not open for further replies.

cr_skyworks

Junior Member level 3
Joined
Aug 4, 2006
Messages
28
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,450
I wan to find the lumped circuit model for any microstrip antenna using HFSS v10. Any suggestions would be appreciated.
 

I have the same problem
 

can anyone post the aanswer for this. thanks in advance
 

In general, you will not find good methods to get lumped element approximations to antennae. Lumped element approximations are good for objects less than about a tenth of wavelength, and most antennae are at least 0.5 wavelengths.

For HFSS, you can try the "low bandwidth" option of the "Equivalent Circuit Export" in the "Matrix Data" panel (right click on a solved Setup to get this option). It may work.

If that doesn't work, this thread has some useful info:
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top