Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Simulation Error in a circuit

Status
Not open for further replies.

Daniz40

Member level 3
Joined
Jan 12, 2006
Messages
57
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,286
Location
Islamabad
Activity points
1,818
error -- less than 2 connections at node

Dear All,
I am trying to build a bandpass filter on PsPice.
There are some errors in it. these are the errors.
ERROR -- STEP device vout is undefined
ERROR -- Less than 2 connections at node VOUT
ERROR -- Node N000471 is floating
ERROR -- Node VOUT is floating ERROR -- STEP device vout is undefined
ERROR -- Less than 2 connections at node VOUT
ERROR -- Node N000471 is floating
ERROR -- Node VOUT is floating

i want to find out the bandwidth of this filter.
I would be grateful if anybody can find out the errors and bandwidth for me
Thanks
 

error--is less then 2 connection

seems u didn't connect the components right try to re-build it.
 

pspice less than 2 connections at node

i have reconnected the circuit at least 5 times. but still the same respone.
what should i do
 

error -- less than 2 connections at node

Daniz40 said:
i have reconnected the circuit at least 5 times. but still the same respone.
what should i do
 

error -- node is floating

BTW Mega is written 'meg' not 'M'
 

less than 2 connections at node in pspice

When I have had this problem I was using the wrong library file, there is a library file that has resisters and stuff, but is only used for drawing, so when you try to simulate everything is floating.
 

step device is undefined

Daniz40 said:
Dear All,
I am trying to build a bandpass filter on PsPice.
There are some errors in it. these are the errors.
ERROR -- STEP device vout is undefined
ERROR -- Less than 2 connections at node VOUT
ERROR -- Node N000471 is floating
ERROR -- Node VOUT is floating ERROR -- STEP device vout is undefined
ERROR -- Less than 2 connections at node VOUT
ERROR -- Node N000471 is floating
ERROR -- Node VOUT is floating

i want to find out the bandwidth of this filter.
I would be grateful if anybody can find out the errors and bandwidth for me
Thanks

The capacitors seems not onnected properly...

At Vout dont put , connector ( page connector ) is not required and check the library also
 

pspice error -- step device is undefined

check your netlist, does netlist macth with schematic?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top