Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Save currents in spectre

Status
Not open for further replies.
Shurik

Shurik

Full Member level 3
Joined
Jul 15, 2004
Messages
166
Helped
16
Reputation
32
Reaction score
4
Trophy points
1,298
Activity points
842
Hello !!!
Can who offer decision of the problem?
I cannot save the currents of circuit in spectre of Affirma!
I select in "Save all" - save currents all !
On all the trys displayed of results in WaveScan, The CIW printed ->

astiCancelSelect(hiGetCurrentWindow())
*Warning* no "IT" data for node "/M0/D"
 

You can select the results you want to plot before the simulation...a roundabout way though!! Outputs>To be Plotted > Select on Schematic....would be better if u can send a snapshot oof the window though!!
 

try putting a 1u Ohm resistor and read the current from it , this happens a lot in spectre in some PDKs
 

Select >
Outputs>To be saved > Select on Schematic.
and save the wires u want ;)
 

safwatonline said:
try putting a 1u Ohm resistor and read the current from it , this happens a lot in spectre in some PDKs
Click to expand...

you can put a vdc=0 which also means a shorted wire and measure current
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top