Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In OrCAD you can create Layout Netlist file for different Layout Tool.
First create a small schematic with resistor or diode.
If you are using OrCAD Layout itself, then create the OrCAD Netlist.
There are few ways to create MNL file.
From OrCAD Layout or from OrCAD Layout Plus create a new Layout.
Select the default template and the created MNL File.
While importing, select Radial for the resistors and select the equivalent PADs.
When the import is finished without errors, it will place in the Layout screen.
Move the device footprints as per the design.
Go for autoroute.
It will create the routing.
Then print.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.