Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to halt IC TCA785 when overcurrent in the galvanisation

Status
Not open for further replies.
T

tinhthanthep

Newbie level 5
Joined
Nov 20, 2006
Messages
9
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,331
tca785

I make a galvanisation machine. I use 3 IC TCA785 to control phase for bridge rectifier 6 thyristors. I want halt the machine when overcurrent. The machine will be reset after turn off and adjust volume back to 0 position. could anyone help me the schematic?
Thanks very much!
 

tca 785

the best solution is:
use one of Hall effect current sensor "LEM" to measure DC current in isolated.
place a low pass filter (RC) and compare it,then you can disable TCA785 in Inhabit pin or using a Integrator + comparator + Reset Relay to down Control Voltage of TCA785.
i Used this solution in DC motor Control.
 

    V

    Points: 2
    Helpful Answer Positive Rating
tca785 schematic

this is simplest form of my solution.
use must adapt it with your circuit.
 

tca785+isolated

Here is modified schematic. What do you think about it?
 

tca785

tinhthanthep said:
I make a galvanisation machine. I use 3 IC TCA785 to control phase for bridge rectifier 6 thyristors. I want halt the machine when overcurrent. The machine will be reset after turn off and adjust volume back to 0 position. could anyone help me the schematic?
Thanks very much!
Click to expand...

can you send me the chematic diagram for 3 IC TCA785 to control phase for bridge rectifier 6 thyristors.
 

ic (tca785)

Hi gujs !

Maybe the datasheet of TCA 785 will help you.
 

Attachments

  • tca785_1557.pdf
    461.7 KB · Views: 260

Re: tca785

tinhthanthep said:
I make a galvanisation machine. I use 3 IC TCA785 to control phase for bridge rectifier 6 thyristors. I want halt the machine when overcurrent. The machine will be reset after turn off and adjust volume back to 0 position. could anyone help me the schematic?
Thanks very much!
Click to expand...

Can any one send me 3 IC TCA 785 ..6 scr control cct or nay type of 3 ph control cct ..
send me to this forum or tnp.de.silva@gmail.com
Thanx
TNP
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top