elektr0
Full Member level 5
Hello,
the solution frequency of HFSS is the frequency, at which the mesh
adjustment is done.
For larger frequency ranges 1..10 or 1...30 GHz the results for lower frequencies get erroneous, if I use the highest frequency as the solution frequency.
How can I fix the problem. If I use different solution setups, with different sol. freq. the result plots are not continuous on the transitions.
Another question, is it possible to force HFSS to calculate a minimum frequency points, when doing the interpolation sweep ?
Thanks for any reply.
the solution frequency of HFSS is the frequency, at which the mesh
adjustment is done.
For larger frequency ranges 1..10 or 1...30 GHz the results for lower frequencies get erroneous, if I use the highest frequency as the solution frequency.
How can I fix the problem. If I use different solution setups, with different sol. freq. the result plots are not continuous on the transitions.
Another question, is it possible to force HFSS to calculate a minimum frequency points, when doing the interpolation sweep ?
Thanks for any reply.