Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

limit output <-10dBm

Status
Not open for further replies.
B

Boowei

Member level 1
Joined
Dec 20, 2006
Messages
37
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
China
Activity points
1,522
My input:-70~10dbm 150MHz
I want output<-10dBm insertion Loss<3dB
I use two PIN diobes parallel connect to earth,but it don't work well,output<10dBm.
who can help me,thank
 

Boowei said:
My input:-70~10dbm 150MHz
I want output<-10dBm insertion Loss<3dBm
I use two PIN diobes parallel connect to earth,but it don't work well,output<10dBm.
who can help me,thank
Click to expand...

use active bais
 

I have used bias voltage on PIN,when Vb<0.7V ,limited output>2dBm
if Vb>0.7v the PIN become a attenuator,the insertion loss will>3dB
 

Boowei said:
I have used bias voltage on PIN,when Vb<0.7V ,limited output>2dBm
if Vb>0.7v the PIN become a attenuator,the insertion loss will>3dB
Click to expand...

so u need, senestive baising.
put coupler (more then 15 dB for good il at the path). put shotkey detector at the coupler, and the vidio out from the detector eill go to the limiter diode
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top