Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Also check the current distribution, especially important in edge coupled lines. See the mesh refinement pictures I posted here:
If you lower Delta_S below the default 2% you must also lower the port refinement along with it or your normalized S-parameters will be inaccurate since calculated Z0 is inaccurate.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
