Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MBC13720 LNA SChematic

Status
Not open for further replies.
K

khanna_gunjan

Member level 3
Joined
Jul 18, 2006
Messages
64
Helped
9
Reputation
18
Reaction score
7
Trophy points
1,288
Location
Nürnberg, Germany
Activity points
1,699
mbc13720

Hello All,

In my application i woulf like to interface MBC13720 LNA from Freescale with MC13192 RF transiever again from freescale for 2.4GHz Application. can anyone post me the reference schematic for this or suggest me the best matching circuit w/o using much external components.

Thanks in advance.

Gunjan
 

mbc13720 application

MBC13720 LNA has only unbalanced output, when MC13192 transceiver has differential RF input (to use a differential antenna).
You can use a balun between LNA output and transceiver input, and keeps the output match recommended by Motorola in the MBC13720 datasheet.
The balun could be microstrip like this Atmel design:
http://www.atmel.com/dyn/resources/prod_documents/doc4779.pdf
or chip:
**broken link removed**
 
lna schematics

Hello vfone,

first of all thank you for your reply. I am using balun from johanson technologies and the schematic is attached herewith. can you please let me know your comments and suggestionon this.

Thanks again
 

microwave lna schematics

I think there is something wrong with this schematic.
The output of the LNA (“RF” in your schematic) should go only to the pin 1 of the balun (2450BL15B200) using C20, and the input of the LNA should go only to the pin 3 of the switch (uPG2012TK) using C1 (and remove C7).
 
murata baluns schematic

hi,

yes you are right C7 i have added just in case we need to use the circuit without LNA. In that case I will not mount the LNA section. and during the test with LNA C7 will not be mounted.

Thanks again, if you have some more suggestions, please do write them, thanks again
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top