Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to design over-current protection and pop&click-supp

Status
Not open for further replies.
A

atxa

Newbie level 4
Joined
Nov 26, 2006
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,312
my project is d-class power amplifier. 2W BTL.
how to consider design a over-current protection and pop&click-suppress circuit.
i ask for help,and hope someone tell some information.thanks
 

Re: how to design over-current protection and pop&click-

place a low value series resistans and check voltage across it if > req. switch off the series pass transistor/ mosfet. for checking use opamp or single tansistor.
are you toking about inside the chip or external to the chip. ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top