Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Need advise on PIC programmer

Status
Not open for further replies.

msmax

Full Member level 1
Joined
May 6, 2001
Messages
99
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Pays Bas
Activity points
919
I used to program PIC's in circuit with good old Tait Serial programmer connected to parallel port and using ICProg1.05a.

This seems not to work with Xp/AMD2200.

So, I'm looking for a SMALL design which can program PIC's in circuit and also works with Icprog and Xp.
It should be a reliable programmer.
Don't like JDM, cause it doesn't program always succesfully.

Any tips!

Thanks.
 

Hi,
You can use Propic XP
**broken link removed**
On download section you can find software schematic and pcb design
 

Try This

Hi friend

Try this go to the ic prog web page and dowload the win2000 driver file

enable the driver using use option bar and then misc and enable the win 2000 driver be sure the driver is in same directory where is ic-prog is lay

your problem is solve

regards
Fragrance
 

Thanks for your fast reply's. Appreciate it.

Fragrance that did the trick. It works fine with XP now. I'm kind of attached to the Serial Tait programmer, cause it is the smallest reliable design I know.

Do I look very stupid now? It was so simple. . .

Once again, thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top