Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

measuring a optocoupler

Status
Not open for further replies.
R

rascabuche

Member level 3
Joined
Jan 29, 2006
Messages
54
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,607
817b optocoupler

can someone tell me how to measure an optocoupler with my DMM to see if its good or bad. i have an optocoupler with 4 pins # l0514the nomber below 817b.

thanks for assistance

Ras
 

optocoupler tester

pins 1/2 are a diode so use a dmm set to diode range

pin 3/4 are a transistor so you can use a transistor tester or dmm again in diode test
however if its short here its gone if its open its usualy ok

the only real way is to build a circuit on a breadboard etc
and plug it in and pulse pin 1/2 with 5v ttl using a 220R current limiter resistor

you can use an led on pin 3/4 and +5v a pullup and load resistor {1k is ok}

here is a picture of a type of method to use
34_1165798474.gif
 

    R

    rascabuche

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top