g.glek
Newbie level 3
Sometimes when I try to simulate an HFSS design I get the following error:
[error] Adaptive solution setup, process abc3d : File write failed in subprocess "wave". Probable cause is running out of disk space. (1:18 ìì Äåê 06, 2006)
I haven't found anything on the net about this one.
It sometimes happens but not always. When I try to do a parametric simulation, only half the variations are finished. What could be wrong here??
My design is a 3d corner reflector with a monopole in it , fed by a lumped port, nothing too complicated.
[error] Adaptive solution setup, process abc3d : File write failed in subprocess "wave". Probable cause is running out of disk space. (1:18 ìì Äåê 06, 2006)
I haven't found anything on the net about this one.
It sometimes happens but not always. When I try to do a parametric simulation, only half the variations are finished. What could be wrong here??
My design is a 3d corner reflector with a monopole in it , fed by a lumped port, nothing too complicated.
