Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MOSFET Confusion. Please Help

Status
Not open for further replies.
P

Popee

Newbie level 3
Joined
Nov 21, 2006
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,327
Hi all,
Im getting a little bit confused as to which mosfet I need. I want it to act with the same 'turn' on characteristics as an NPN Bi-polar transistor.

E.G High resistance when no voltage is applied to the gate and then a low resistance when a positive voltage is applied to the gate

I thought the correct MOSFET to choose was a N Type Mosfet with Enhancement. Can anyone clear this up for me?

regards, Lee S
 

yes, you are right. you can use a NMOS transitor
 

Hi all,
Im getting a little bit confused as to which mosfet I need. I want it to act with the same 'turn' on characteristics as an NPN Bi-polar transistor.

E.G High resistance when no voltage is applied to the gate and then a low resistance when a positive voltage is applied to the gate

I thought the correct MOSFET to choose was a N Type Mosfet with Enhancement. Can anyone clear this up for me?
Click to expand...

Hello, Yes you need N type. I think the reason of your confusion is the point that you measure your voltage in reference to that. in bipolar npn if voltage base to emitter is 0 then collector will be high Z. in Mosfet N channel if gate to source voltage be 0 then drain will be High Z and when you give a voltage to gate more positive than threshold voltage of mosfet in reference to source(this threshold voltage is different for each mosfet) then impedance of channel(drain to source) will be decreased. more positive less impedance until you reach a plateau. read datasheet of an N-Mosfet and look at graphs. it will be clear to you.
good luck
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top