Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Uboot serial's message not completed!What's the problem?

Status
Not open for further replies.
S

sirong671

Newbie level 2
Joined
Nov 17, 2006
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
My serial's message is as follow:
U-Boot 1.1.4 (Nov 15 2006 - 14:41:06)

U-Boot code: 33F80000 -> 33F96B84 BSS: -> 33F9AE70
RAM Configuration:
Bank #0: 30000000 64 MB
Flash: 512 kB
*** Warning - bad CRC, using default environment

But there is not
In: serial
Out: serial
Err: serial
bks2410＃
What's the problem!I checked the serial .It's OK!
 

Do you get a U-Boot prompt?

If yes then it might be possible that you defined CFG_SERIAL_CONFIG_QUIET or CFG_CONSOLE_CONFIG_QUIET something similar
(I do not recall the exact name and do not have the sources with me right now.)
Then it does not print out this information.

Otherwise it might be possible that your u-boot environment maps these on other ports. (and the rest of the information is send to these ports).
Or perhaps that U-Boot crashes before the initialisation of the console is started.

Antharax
 

    S

    sirong671

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top