Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Mixer noise modeling using ADS

Status
Not open for further replies.
G

Grig

Full Member level 4
Joined
Sep 3, 2004
Messages
220
Helped
36
Reputation
72
Reaction score
12
Trophy points
1,298
Activity points
1,469
Hi

The ADS simulation of transistor level mixer schematic produces Sopt Rn and
NFmin
The problem is ...
system mixer models Mixer Mixer2 MixerHBData produce different result for noise figure when Sopt Rn and NFmin are used (I have idea why...)

How to model mixer noise using system mixer model?
Somebody know proper procedure?

Regards
 

what do mean that the system level simulation give different , and did u measured the performance of a circuit , then u want to make a model for it

khouly
 

Thanks for reply

My procedure was
1.Simulate transistor level ckt obtain Nfdsb Nfssb and twoport parms Sopt Rn and NFmin
2.Substitute two port parameters to system mixer model like Mixer2
3.Simulate with Mixer2 and see NFdsb and NFssb

I see that Mixer2 produce different NFdsb and NFssb
 

check ur analysis type u use with Mixer2 ,
mainly check the notes in the manual about Mixer2

could u upload ur project to check it ?

khouly
 

i have check the file , but i donot know what is the problem , everything seems to be good

maybe someone can help

khouly
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top