Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

16 segments mapping and ram bank

Status
Not open for further replies.

Hermano Canguro

Junior Member level 2
Joined
May 16, 2006
Messages
21
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,448
I'd like use a msp430fg438 to drive a 8-digits
16-segments LCD panel, the use of a particular
configuration ram-bank (that mean a particular
bit represente a particular segment) depends just
of the pin out ? I couldnt get information about why
in the different aplication notes use so extrange
distribution of the bank ram. I should do first the
route on a PCB board and after that implement a
code for drive each digit ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top