Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

about the process for PLL

Status
Not open for further replies.

gingerjiang

Full Member level 3
Joined
Mar 1, 2006
Messages
171
Helped
17
Reputation
34
Reaction score
6
Trophy points
1,298
Activity points
2,181
hi all
i will design a pll.
i want to know if i need a special process for the pll, because the vco will be integrated on the chip.
thanks advance!
 

i think the mixed signal CMOS process will be ok , and should include thick metal for inductor implementation

khouly
 

    gingerjiang

    Points: 2
    Helpful Answer Positive Rating
khouly said:
i think the mixed signal CMOS process will be ok , and should include thick metal for inductor implementation

khouly

thanks khouly
i use a mixed signal process indeed, but this process don't provide inductor. will i design this inductor and simulator it myself?
 

of course u need to design the inductors by yourself and simulate it , and measure it
but u will need full em simulation to get the best results

and it's preferred that the process contain a thick metal option , and accumulation mode varactors


khouly
 

    gingerjiang

    Points: 2
    Helpful Answer Positive Rating
u can always do ring oscillator

Added after 28 seconds:

if ur phase noise spec aint that tough
 

    gingerjiang

    Points: 2
    Helpful Answer Positive Rating
Dear gingerjiang

what is ur PLL target application ?

FS , CDR , modulation , demodulation , clock sync ,

khouly
 

khouly said:
Dear gingerjiang

what is ur PLL target application ?

FS , CDR , modulation , demodulation , clock sync ,

khouly

Dear khouly

I want to design a frequency synthesizer, but I am only a beginner.

I find some softwares for inductor calculation, e.g. appcad, spiral etc., but I don't know whether these tools are enough to design an inductor. I have the doubt about these tools that they don't consider all factors.
 

for inductor design , u should use some EM simulator , and model the inductor good , to get all the paracitics , and so on
u can use momentum , Sonnet , HFSS , whatever u want

khouly
 

    gingerjiang

    Points: 2
    Helpful Answer Positive Rating
Hi
Take attention to isolation of analog and digital parts
Dig part produces noise and sfdr of analog parts degrades
 

    gingerjiang

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top