Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Pulse width modulation

Status
Not open for further replies.
E

ei99dami

Newbie level 4
Joined
Sep 26, 2006
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,336
I have problem to make a pwm with high frequency and high resolution. I´m using a internal clock of 160 MHz and I get a pwm of 1.25 MHz and a resolution of 4 bits. I have made my pwm by using a comparator a ROM-table and 2 counters.

How do I do to make a pwm with higher resolution och higher frequency?

How is this made for example for pwm for audio, are they using more outputs to make more resolution?

/Robin
 

To create a 4 bit pwm with a compartor to compare a counter with a ROM-table it will be 7 bits lower frequency (if detecting on both falling and rising edge on the clk else it will be 8 bits). Se attachment "pwm_scheme" on the scematic.

I hope it can be done in another way.

I´m going to create a sinus (5-10 MHz) with as high resolution a possible.

My internal clk alternative is max. 500-600 MHz.

It seem that sigma delta modulation is for lower frequency, and by that it is possible to get higher resolution?

/Robin
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top