Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Is there a model for VCCS in Simulink?

Status
Not open for further replies.
DZC

DZC

Full Member level 2
Joined
Sep 12, 2006
Messages
149
Helped
13
Reputation
26
Reaction score
5
Trophy points
1,298
Activity points
2,122
vccs transfer function

I want to model a two pole amplifier to analysis the settling behavior.
At first I tried the transfer function using zero&poles,but the simulation seemed couldn't carry out due to the high pole.
Now I'm trying to build the model with R,C,and VCCS,but I can't find the VCCS model.
Any good idea?
Regards
 

simulink vccs

Yes.
Open Simulink>SimPowerSystem>Electrical sources : Use a Controlled Current Source

For the control terminal, use the output from a voltmeter as the control signal. You'll find the voltmeter at:
Simulink>SimPowerSystem>Measurements>: Use a voltmeter.
 

    DZC

    DZC

    Points: 2
    Helpful Answer Positive Rating
vccs in simulink

I've tried it.But I just can't find the gm parameter or something like that...
 

how to design a voltmeter with simulink

gm=Iout/Vin,
It can be a multiplier or gain block between the measured voltage ouput and the source's control signal input port (s). its 1 by definition
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top