lawrence_idol
Junior Member level 3
hello to all expert,
im just a newbie in doing FPGA..
i have a high interest on doing FPGA project in my final year B(ENG)..
Im about to do an Arithmetic operator such as simple DSP processor to filter out noise..
2 input signal fed into ADC (5volt Sine wave or sound + 3volt Noise)
then it have one 8 bit adder to sum up 2 signal.
Afterall the arithmetic would perform as FIR or IIR filter
to filter out noise signal..
finalist obtain 8V pure signal transfer to DAC.. Out put point end here
Im using Altera UP-1 and UP-2 board which contain MAX7000s & flex10K
Could some one help me. i would be very appreciate if someone could share his knowledge to me..
Here are the picture illustrate my project.
im just a newbie in doing FPGA..
i have a high interest on doing FPGA project in my final year B(ENG)..
Im about to do an Arithmetic operator such as simple DSP processor to filter out noise..
2 input signal fed into ADC (5volt Sine wave or sound + 3volt Noise)
then it have one 8 bit adder to sum up 2 signal.
Afterall the arithmetic would perform as FIR or IIR filter
to filter out noise signal..
finalist obtain 8V pure signal transfer to DAC.. Out put point end here
Im using Altera UP-1 and UP-2 board which contain MAX7000s & flex10K
Could some one help me. i would be very appreciate if someone could share his knowledge to me..
Here are the picture illustrate my project.
