Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

FM modulation with PLL+VCO

Status
Not open for further replies.

7rots51

Advanced Member level 4
Joined
May 17, 2002
Messages
1,183
Helped
25
Reputation
50
Reaction score
12
Trophy points
1,318
Activity points
9,636
how to modulate a signal (FM) by using a PLL+VCO system?
 

1) Modulate VCO control line. PLL lopp bandwidth must be narrower than modulation bandwidth and injection circuity must be very high impedance, or AC coupled, so it will not cause leakage from charge pump. This techniquie is "high pass"

2) Modulate reference. This is "low pass"

3) Do both, reserach "two point modulation". This is "all pass".
 
  • Like
Reactions: ferdem

    ferdem

    Points: 2
    Helpful Answer Positive Rating
please give some ref links or articles.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top