Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How are comparators used

Status
Not open for further replies.
invent

invent

Member level 4
Joined
Sep 6, 2006
Messages
78
Helped
10
Reputation
20
Reaction score
4
Trophy points
1,288
Activity points
1,769
All I know is that comparators are used to compare signals and they are very important therefore are used in many types of circuits.

So how are comparators used in these circuits?
What makes a good comparator in different application?
Is faster response time and larger output voltage always better?
 

invent said:
All I know is that comparators are used to compare signals and they are very important therefore are used in many types of circuits.

So how are comparators used in these circuits?
What makes a good comparator in different application?
Is faster response time and larger output voltage always better?
Click to expand...

sometimes offset,sometimes response time,sometimes current
depend on application
 

For example: you may need to synchronize your circuit to the mains voltage, 50 or 60 Hz. If you connect one input to ground and another input through a large resistor and cliping diodes to the mains line, you can get a "1" logic level during the positive half wave and "0" during negative. For decoupling better to take the mains sine signal from a transformer secondary. But always remember that in area where to inputs' voltages are close to each other, the comparator will oscillate with a high frequency. So in the case of slow changing signals (like described above) one should add enough histeresys, using a positive feedback to the non-inverting input.
 

    invent

    invent

    Points: 2
    Helpful Answer Positive Rating
Comparator has three important parameters: offset, gain, speed. Which one is more important depends on your application.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top