Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to remove the noise signal on receiver?

Status
Not open for further replies.

eugenehhk

Member level 1
Joined
Sep 6, 2006
Messages
34
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,529
I have a 433MHz TX/RX module(digital,ask), some noise signal is detected on the RX, I would like to ask how to remove the noise? Would u think that the problem would be improved if encoder and decoder is used?
If I want the circuit small, and low cost (not use encoder and decoder), do u have another approach to remove the noise?
THX:)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top