wylee
Full Member level 1
ahdllib
I want to use a square wave vco to run some test on my circuit, I found this "dig_vco" cell inside "ahdlLib" but I can't make it work
Can anyone teach me how to configure this component?
I am ramping a voltage source from 0.7V to 1.4V (within 0s to 1u)
Attached is the snapshot of how I connect my VCO & parameter values
I want to use a square wave vco to run some test on my circuit, I found this "dig_vco" cell inside "ahdlLib" but I can't make it work
Can anyone teach me how to configure this component?
I am ramping a voltage source from 0.7V to 1.4V (within 0s to 1u)
Attached is the snapshot of how I connect my VCO & parameter values