Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need help for ADS- errors, source bandwidth, time step contr

Status
Not open for further replies.
S

sunwiss

Junior Member level 3
Joined
Dec 5, 2002
Messages
28
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
207
When we simulate, errors accur as the following,
"Warning detected by HPEESOFSIM during TRAN analysis `Tran1'.
MaxTimeStep reduced to 6.944e-011 to resolve source bandwidth.
Warning detected by HPEESOFSIM during TRAN analysis `Tran1'.
Internal timestep 9.09495e-023 too small at time 2.06961e-019
while simulator using Truncation Error time step control.
Simulation proceeds with Iteration Count time step control.
Error detected by HPEESOFSIM during TRAN analysis `Tran1'.
Internal timestep 6.25000e-023 too small at time 2.41961e-019.
".
Why? What should I do?
 

Some times the simulations do not converge using default settings
Try using a step of (0.1/Frequency) and try playing around with the
transient simulation settings. Unless you become more specific about
the model components that you use there is no way to further assist you.
Take a look in the ADS examples (especially the one reffering to
Transient Assisted Harmonic Balance) since some very nice convergance
tricks are used there.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top