Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to design a 1W power amplifier using ADS tools?

Status
Not open for further replies.

microwavehongjie

Member level 1
Joined
May 9, 2006
Messages
36
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,515
hi,
i need a help regarding how to design a 1W power amplifier using ADS tools. is there any design example available? and could i design it with small signal S-parameter simulation for its low output power? Or i have to design it with hamonic balance simulation?
pls help ,thanks a lot for the info!
 

Re: power amplifier!

usually in power amplifier design u need to use LSSP , which is based on HB simulation , small signal S parameters are not ususally used in PA

also it will be not vaild at all if u design a class C PA

so use HB , or LSSP

khouly
 

power amplifier!

hi,

khouly,thank u very much! is there any design example available for me to do it with LSSP simulation? i think , the examples given in the ADS is not available for me. and now i will design a 1W 1G to 10G PA which is not MMIC, could u give me some advice?

thanks again!

microwavehongjie
 

Re: power amplifier!

i will design PA at 6 GHz , 1 W , soon , but i am not seeign which transistor to use

so if u have a transisitor tell me

thanks

khouly
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top