sunshinezhuzhu
Newbie level 1
Hi, all
I am trying to simulate the electric field distribution inside the water filled circular glass tube, while the incident wave is the TE10 mode of the waveguide(with the flange connected to one end of the cavity).
I also set up a air box more than quarter wavelength away and assign radiation boundary around it.
The hfss file is attched.
However, when I run the simualtion, an error occurs on my wave port setup.
" [error] Port refinement, process abc3d : Port "WavePort1" is incorrectly set up. A port must have a non-existent material on one side. Both "Box3" and "Box2" exist. "
I have no idea about how to set up a wave port at the interface of the waveguide and the background air.
Can anyone help me with this? And are there any other errors in my model setup? Thanks a lot for your kind help. I appreciate it.
zhuzhu
I am trying to simulate the electric field distribution inside the water filled circular glass tube, while the incident wave is the TE10 mode of the waveguide(with the flange connected to one end of the cavity).
I also set up a air box more than quarter wavelength away and assign radiation boundary around it.
The hfss file is attched.
However, when I run the simualtion, an error occurs on my wave port setup.
" [error] Port refinement, process abc3d : Port "WavePort1" is incorrectly set up. A port must have a non-existent material on one side. Both "Box3" and "Box2" exist. "
I have no idea about how to set up a wave port at the interface of the waveguide and the background air.
Can anyone help me with this? And are there any other errors in my model setup? Thanks a lot for your kind help. I appreciate it.
zhuzhu