Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi
the IDE doesnt deside which type of hardware u wnat to use u have to physically connect the PIc to a 7segment display & program the controller such that i will out put the number that u pressed on the input side here is sample circuit.
the 7 sement should be either common anode/cathode type
Really a lot information regarding this topic on the Internet.
Attached find documents show the full source code and schematic that I used for one of my commercial projects in the past.
Driving 4" 7-segment LED. Multiplexing method used. Development in CCS C programming language. Pictures found under my web page under PIC Boards section.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
