Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank's to all for responding. I appreciate this a lot.
What i need is to build an new hardware programmer called "PICALL programmer", you can find some view of schematics and PCB at https://www.picallw.com. On this programmer board, there is a PIC controller and i can't find anywhere the bin file (or better the source code), to burn this pic controller ! (i can burn it because i have a p16Pro hardware programmer), these two Hardware Programmers can be used with the PICALLW Soft . Sorry if I'm confusing....
If any of you have this bin file (or better the source code), or if you know where i can find it, or another way to get around it .....let me know please.
This is a commercial device and builder of this programmer sells preprogrammed picallw chips in his site.Pre-programmed chips are protected and you can't find its hex file.Best solution is to visit there and buy a programmed chip.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
