Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CCS problem with DSK6711

Status
Not open for further replies.
A

ahmadagha23

Guest
Hi
My DSK6711 board worked properly but after some times using paralel port cable for programming it,I recieve the following message from
Code Composer Sudio 2. Can you help me to avoid this message and use the DSK?

Can't Initialize Target CPU:
Error 0x80000200/-700
Fatal Error during: OCS,
This is a TI USCIF adapter library (Sourceless EPK) error.
POD ERR_RESET <-700>
Error detectec during reset

I/O Port =378

Board Name:C6711 DSK
CPu Name:CPU_1
...

Regarding that I have checked all the required setting for using the DSK with parallel port cable, is the message because of hardware damage?

Regards
 

Hi

Check Crystal oscillator or Crystal assosiated with the DSP to make sure that it is running.
 

hi.....
am a beginner for DSP.
plz hhelp to start my programming in TI DSP 's
regards
meka
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top