flushrat
Full Member level 3
ppar cdl
how to get a flatten netlist in cadence?
Added after 1 hours 14 minutes:
I have find a way but still face problems.
In ADE, set setup->simulator to hspiceS, choose flat for netlist type in setup->environment, then generate netlist from simulation->netlist->creat final.
It does work when no parametered cell are used. But in my schematic, there are lots of parametered cells such as inverters, nand...
Below is log:
*Error* in expression: ""(5.4e-07+2.7e-07*(pPar(\"m\")*2-2)*2)/pPar(\"m\")/(pPar(\"w\")*2)"", on CDF Parameter: nrs, AEL's message: data type error: no operators defined for non-numerics: "1"
here m is the finger number, w is the width of pmos
how to get a flatten netlist in cadence?
Added after 1 hours 14 minutes:
I have find a way but still face problems.
In ADE, set setup->simulator to hspiceS, choose flat for netlist type in setup->environment, then generate netlist from simulation->netlist->creat final.
It does work when no parametered cell are used. But in my schematic, there are lots of parametered cells such as inverters, nand...
Below is log:
*Error* in expression: ""(5.4e-07+2.7e-07*(pPar(\"m\")*2-2)*2)/pPar(\"m\")/(pPar(\"w\")*2)"", on CDF Parameter: nrs, AEL's message: data type error: no operators defined for non-numerics: "1"
here m is the finger number, w is the width of pmos