Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

slew rate simulation question

Status
Not open for further replies.
C

chungming

Full Member level 1
Joined
Mar 23, 2006
Messages
96
Helped
3
Reputation
6
Reaction score
0
Trophy points
1,286
Activity points
2,041
Hi~~
i have a question about how to simulate slew rate in fully differential switched cap CMFB OPA?
like attached file
Why using 1M Ohm? is more larger more better?
and why using 6.8pF cap as unit gain , why don't use other number?
thanks~~!!
 

I guess 6.8p capacitor may be the requirement of your system.
Too big resistor will degrade the cm voltage on input node for the reason of voltage division.
 

i dont understand ur schematic. is the (diff OPAMP) block shown is the ideal or practical model/ or it is a schematic???
 

Hallo


If u want to see the result in Transient simulation ..u have to take the difference of the two outputs then u'll real out put

ciao
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top