Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
it means that channel lenght is short ,
u know the MOS is isolated gate device, where the gate potential "metal, infact polysilicon" is used to control the flow of the current in the MOS , the metal gate dimension are Length "L" and width "W" , the current is proportional to the aspect ration W/L"this means that aboslute values are not setting the current but the ratio(this is not really accurate but it is good for the explaination)" , as technology advance the dimension shrinks , this allow faster and smaller MOS "actually the freq. is inversly proportional to L, i.e. decreasing channel length increase ft ",in current techonlogy also called DSM "deep sub micron" the gate length is few hundereds "now tens" of nanometers this is really short length and hence the name.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.