Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ic5141 on RHEL 3 and RHEL 4

Status
Not open for further replies.
A

asueee0

Advanced Member level 4
Joined
Dec 26, 2005
Messages
109
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,299
no problem to install ic5141 on RHEL AS 3, but when trying AS 4, there are some error message shown up (i just directly ran seup.sh, and the message disappear very quik, i don even had a chance to see it) anyone could give some clue or idea to install it?
 

don't double-click SETUP.SH, try to run it from the terminal. This will give u time to read the error.
 

    A

    asueee0

    Points: 2
    Helpful Answer Positive Rating
but how to run setup.sh in a terminal, just type it and return?
 

change to the directory where the setup.sh script is located first.
So if your setup.sh script is in /usr/cds/ic/setup.sh
you can either just type in the full path like: /usr/cds/ic/setup.sh and run the script. Or you can do:
cd /usr/cds/ic
and run setup.sh like: ./setup.sh
 

    A

    asueee0

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top