Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

BandPass using single supply opamp????

Status
Not open for further replies.

Elits

Member level 4
Joined
Jul 27, 2005
Messages
79
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Indonesia
Activity points
1,982
Hi all,
1. i want to know how to filter the noise of square wave (50kHz)? because when i use Bandpass for sinusoidal wave , my square wave was differentiated (HPF) and Integrated (LPF).
2. How to make bandpass using single supply Opamp (LM324)? is the configuration same if we use double supply opamp? I want to make bandpass (100Hz-14kHz) for audio but using single supply opamp..

please help me
Thanks

Elits
 

To eliminate the square 50Hz, you must remember the componets of this signal:

at 50Hz, 3*(50Hz), 5*(50Hz), 7*(50Hz) . . . . . . . . . .

You must use a notch filter and take decide how many harmonics you want to eliminate.

Example 2 harmonics, an you fl < 50Hz and fh > 350Hz
and use a 3rd order filtersand take care that those frequencies stays on the reject band.
 

Of course you can build circuits with opamps and supply them of a single supply rail ..
The trick is that instead of using 0V as reference, as is the case with dual-supply, you will need to reference inputs to 1/2 Vcc, and between stages you will need to use coupling capacitors ..

A bandpass filter for that range (100Hz - 14kHz) can be build of connected in series (cascade) high-pass (100Hz) and low-pass (14kHz) filters ..
Below is an example of single supplied LPF + HPF ..

If you would like to read more on the single supply of opamps issue here is the link:
"A Single-Supply Op-Amp Circuit Collection"
One of the biggest problems for designers of op-amp circuitry arises when the circuit must be operated from a single supply, rather than ±15 V. This application note provides working circuit examples.
**broken link removed**

Regards,
IanP
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top