Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

2313 Programming Board

Status
Not open for further replies.
P

pulse0

Newbie level 4
Joined
Apr 23, 2006
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,334
I'm trying to build this programing board but it does not tell me the exact parts list.

If anyone has built this board can you please give me a list of all the components.
Or even if you have not built this board but you can read that schematic better than me can you please give me the parts I would need
There are 2 capacitors, one resistor one transistor a "3-prong capacitor RES1" ?
But I couldn't make out the values of any of these components.

help pleaseeee

**broken link removed**
 

Hello!

As you can see C1 is 47uF and C2 is 100nF. IC1 is not a transistor. It is a regulatos which regulates the voltage to the 5v.

I think that R1 is something like 10kohms. And finally so called "3-prong capacitor RES1" is a resonator. Resonators value is 8Mhz. S1 is a reset switch.

If you are interesting about a little larger programming environment, check this site: **broken link removed**

From there you can download the manuals which includes scematics for that board.

I hope that I hepeld you :D
 

    P

    pulse0

    Points: 2
    Helpful Answer Positive Rating
Thank you, thanks for your help. I do not have a resonator that is 8MHz. Would it still work if I use a 6Mhz or 12MHz?
 

Yes it works with 6MHz resonator, but I think 12MHz is too much, but you can try it if you want..

What kind of compiler do you have? CodeVision AVR is really good choice o programming practising. And if you want, I may give you some examble codes..
 

    P

    pulse0

    Points: 2
    Helpful Answer Positive Rating
I have CodevisionAVR C Compiler. Can you give me some example codes some simple ones like blinking an LED and stuff. I'm completely new in this field so I'm trying to start from scratch and then build on that.
 

Sori.. I was in a holiday.. But now I'm back... :D

What kind of test environment you have? Because I need to know the pin defines that I can make the codes.. And if it's possible upload schematics. Tahat would help me a really much.

Tugge
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top